Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

UdpJitter(codec) configuration using SNMP

Hi,

Who can told me order of setting objects for UdpJitter(codec)operation?

For example following is order of setting objects for UdpJitter without codec:

rttMonCtrlAdminRttType.<index> -Integer 9

rttMonEchoAdminProtocol.<index> -Integer 27

rttMonEchoAdminTargetAddress.<index> -OctetString "05 00 00 02"

rttMonEchoAdminTargetPort.<index> -Integer 8000

rttMonEchoAdminInterval.<index> -Integer 20

rttMonEchoAdminNumPackets.<index> -Integer 100

rttMonCtrlAdminStatus.<index> -Integer 4

rttMonScheduleAdminRttStartTime.<index> -TimeTicks 1

Thanks ahead

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: UdpJitter(codec) configuration using SNMP

You can insert the rttMonEchoAdminCodecType just before rttMonCtrlAdminStatus. However, you cannot specify rttMonEchoAdminPktDataRequestSize, rttMonEchoAdminInterval, or rttMonEchoAdminPackets if you specify a codec. See the CISCO-RTTMON-MIB for more details.

2 REPLIES
Cisco Employee

Re: UdpJitter(codec) configuration using SNMP

You can insert the rttMonEchoAdminCodecType just before rttMonCtrlAdminStatus. However, you cannot specify rttMonEchoAdminPktDataRequestSize, rttMonEchoAdminInterval, or rttMonEchoAdminPackets if you specify a codec. See the CISCO-RTTMON-MIB for more details.

New Member

Re: UdpJitter(codec) configuration using SNMP

Thanks very much!

148
Views
0
Helpful
2
Replies