Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Unable to activate monitor capture - cisco ASR1001

Hi Guys,

I need to troubleshoot an package loss issue and for that I would like to use "monitor capture" but it just do not start, see bellow.

ASR1001#sh monitor capture cap_out

Status Information for Capture cap_out
  Target Type:
   Interface: GigabitEthernet0/0/1, Direction: both
   Status : Inactive
  Filter Details:
   Access-list: acl-out
  Buffer Details:
   Buffer Type: CIRCULAR
   Buffer Size (in MB): 10
  Limit Details:
   Number of Packets to capture: 0 (no limit)
   Packet Capture duration: 60
   Packet Size to capture: 0 (no limit)
   Maximum number of packets to capture per second: 1000
   Packet sampling rate: 0 (no sampling)

ASR1001#monitor capture cap_out start

Unable to activate Capture.

Did anyone face that?

Regards

Everyone's tags (1)
2 REPLIES
New Member

I had this problem too.When I

I had this problem too.

When I cleared the "log" extension at the ends of the access-list lines then the problem have been settled.

New Member

Thanks, worked for me.

Thanks, worked for me.

548
Views
10
Helpful
2
Replies
CreatePlease to create content