I have a cisco 2600 router which is in my office network...and AAA authentication enabled , it contacts AAA server and authenticate...my problem is that all my routers authenticate with aaa server..even this router...but for alone this router it is not asking enable password...when typing first username and password itself it takes to # prompt...(privillage mode). but in all other routers aaa server asking enable password...I have local username, password and enable password configured in the same router locally also..but when i tries with out AAA server the same thing happens...it is not asking enable password...after entering local usernames and password...it enters # prompt..with out..entering enable password... is this is problem with ios??
am including the reasult of the sh version command....thanks...in advance...
Cisco IOS Software, 2600 Software (C2691-SPSERVICESK9-M), Version 12.4(10a), REL
EASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 11-Oct-06 18:39 by prod_rel_team
ROM: System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1)
uptime is 9 weeks, 18 hours, 49 minutes
System returned to ROM by power-on
System restarted at 00:00:00 UTC Fri Mar 1 2002
System image file is "flash:c2691-spservicesk9-mz.124-10a.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco 2691 (R7000) processor (revision 0.1) with 249856K/12288K bytes of memory.
Processor board ID FHK1050F1WH
R7000 CPU at 160MHz, Implementation 39, Rev 3.3, 256KB L2 Cache
2 FastEthernet interfaces
4 Serial(sync/async) interfaces
1 ISDN Basic Rate interface
DRAM configuration is 64 bits wide with parity disabled.
55K bytes of NVRAM.
62720K bytes of ATA System CompactFlash (Read/Write)
Configuration register is 0x2102
