Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Unable to populate DRC

I believe that I am correctly placing the seed device, I run a discovery and get 0 number of devices discovered.

10 REPLIES
Cisco Employee

Re: Unable to populate DRC

What version of Common Services do you have?

New Member

Re: Unable to populate DRC

Hi J,

3.1.1

Cisco Employee

Re: Unable to populate DRC

Please post your NMSROOT/conf/csdiscovery/CSDiscovery-config.xml as well as your CSDiscovery.log file.

New Member

Re: Unable to populate DRC

Will I have these files even if I used CDP and tried to designate a seed device. Thus far I am doing a search for the first file with no success.

Cisco Employee

Re: Unable to populate DRC

If you have Common Services 3.1.1, then you should be using Common Services Discovery, and you must have the CSDiscovery-config.xml file.

New Member

Re: Unable to populate DRC

Suppose this is the incorrect way of sending the CSDiscovery log. Did no find the first file.

Cisco Employee

Re: Unable to populate DRC

The config file is the most important. Note: NMSROOT is the path into which you installed LMS.

New Member

Re: Unable to populate DRC

J,

Thanks for your direction.

Cisco Employee

Re: Unable to populate DRC

Your IP range only allows two devices to be discovered: 143.79.3.2 and 143.79.3.0. I think what you meant was something like the following:

143.79.*.*

Your seed device of 143.79.*.* is also invalid. Just delete that seed. Seed devices should be absolute IP addresses.

New Member

Re: Unable to populate DRC

LMS is working per your instructions. Thank you for resolving my issue (s).

148
Views
5
Helpful
10
Replies
CreatePlease to create content