I have a number of 2950s on a remote site I am trying to upgrade via CNA - the .tar file is on a TFTP server at the remote site, and CNA is running on a PC at the local site, with a VPN connection between the two sites
2950+----<--VPN-->Local CNA PC
The TFTP server is on the same subnet as the VLAN interface on the 2950.
However, when I try to use CNA to perform the upgrade, the upgrade fails, with the following messages in the status window:
Uploading the image
Extracting the info file from the image
Software upgrade failed
I have run a packet capture on the remote network and there is no TFTP traffic between the switch and the TFTP server. Does CNA support upgrades in this environment? I can access the image on the TFTP server via command line on the remote switch, but as I have a large number of switches across multiple sites, I was hoping to use CNA to ease the upgrade process as far as possible.
There is a 'details' button that may provide more information on what's going wrong. I had some 2950s that failed upgrades, it turned out to be a lack of memory ... deleting the old firmware solved the problem. This may or may not be your problem, but in my case the problem became obvious after reading the 'details'.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...