Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Updating Telnet Credentials

I am running LMS 2.6 and since we can't set a default for the telnet credentials, I'd like to know if there is a way to run a job that sets these passwords on all devices at the same time? All devices have different community strings so I don't want those to all be the same. Is there a way to just change the Telnet Passwords all at the same time? thanks, marcie

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Updating Telnet Credentials

Do NOT touch any field you do not want to change. Just change the fields that should apply to all devices.

4 REPLIES
Cisco Employee

Re: Updating Telnet Credentials

Sure. Just go to Common Services > Device and Credentials > Device Management, select all your devices, then click on Edit Credentials. Only fill in the telnet credentials, then click Finish.

New Member

Re: Updating Telnet Credentials

Ok, but I just want to make sure of one thing...when I do that and bring up Standard Credentials page there appears to be entries for the community strings (dots)....should I delete these? Will that remove them from the DB when I apply?

Cisco Employee

Re: Updating Telnet Credentials

Do NOT touch any field you do not want to change. Just change the fields that should apply to all devices.

New Member

Re: Updating Telnet Credentials

thank you!

105
Views
0
Helpful
4
Replies