How did you run the upgrade analysis? Did you use Cisco.com or your repository? I just imported this image into my local repo, and ran an upgrade analysis, and I see the correct RAM and Flash values.
Then I did an upgrade analysis from Cisco.com, and that worked as well. If you are running your report against your local repository, you may have a bad import. You can try removing and re-importing the image, or adjust the image options by clicking on the image name in your repository browser.
The image attributes are those same values you see in your earlier Cisco.com screenshot. Those values should be obtained automatically, but it looks like there may have been a problem with your import. Try removing the image from your repository, then import it again. You should get the attributes then. It worked for me.
Alternatively, for this particular image, you know them to be 64 MB of Flash and 128 MB of RAM, so you could update the attributes manually.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.