Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrade Frameware

I am a new user for LMS 3.2

i have to issue to do but i don't know how

1 - I want to Upgrade the Frameware of my switch from the LMS, there are any configurations needed on the Switch?? and how i can Upgraded them?

2 - I want to Backup the Swtich configurations to my Hard disk, how i can do this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Upgrade Frameware

Uncheck all of the boxes except "Include Cisco.com images for image recommendation" and you should be set.

8 REPLIES
Cisco Employee

Re: Upgrade Frameware

For performing software upgrades using the Software Image Management feature of RME, see http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.3/user/guide/swmgt.html .  To make sure your devices have the proper configuration for doing software upgrades, see http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.3/user/guide/swmgt.html#wp1313744 .

RME will automatically archive the configurations from your devices as soon as it manages them.  To make sure this happens, you need to have correct credentials for the devices in the Device Credential Repository.  You must have at least an SNMP read-write credential configured or telnet/SSH usernames and passwords.  More details on configuration archive management can be found at http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.3/user/guide/config.html .

New Member

Re: Upgrade Frameware

ok, i try to create step by step

first i setup the user name and password in cisco.com user Account Setup in picture 1

second i try to upgrade knowledge base, i get the message in pictures 2 and 3

i can't go to the step 2

then i add a Software Repository Management for one off my switch, i downloaded all is fine in picture 4

then i configure my switch, i create rcp and i configure all traps and community, and i modify the system preferences with cwuser created in rcp

finally wen i go to software distribution i select the device, i get this result in picture 8

i have some miss configurations?? what is the problem??

New Member

Re: Upgrade Frameware

Another problem bring up i have an error when i communicate with my switch,

i check the configuration of SNMP, it's Read and Wright (RW)

i can view the configurations changed in RME, it's updated normally,

i can get all syslog

but the devices are Unreachable in picture 1

and i can't open ciscoview i picture 2

i don't understand, the problem is with the communications!!!

NB: i can connect via telnet

New Member

Re: Upgrade Frameware

any body can help me?

Cisco Employee

Re: Upgrade Frameware

Start a new thread for this issue.

Cisco Employee

Re: Upgrade Frameware

Post a screenshot of RME > Admin > Software Mgmt > View/Edit Preferences and the swim_debug.log.

New Member

Re: Upgrade Frameware

This is what you ordered and thank you for your cooperation.

Cisco Employee

Re: Upgrade Frameware

Uncheck all of the boxes except "Include Cisco.com images for image recommendation" and you should be set.

469
Views
0
Helpful
8
Replies