I need to use ciscoworks to configure 6509 using SNMP protocol. Our Cat6509 has 2 ip addresses: 1 for Layer2 and 1 for layer 3. When I tried to open CiscoView to connect Layer3 IP address, it prompted:"it is subdevice, you need to open parent." Then I open via Layer2 IP address, I don't know how to change the configuration in the layer 3 part.
Launch CiscoView on the Supervisor IP address (i.e. layer 2 management address). Next to the Supervisor module in the chassis view, you will see a router icon. Right-click on this icon, and you will be able to monitor and configure MSFC details.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.