User defined task RME 4.0.5

[u346874_2]

I m trying to make in RME-config mgmt-net config new user defined task which copy the startup-config to E.g disk0:.

Problem is how can i tell when creating user defined task that after command "copy startup-config disk0:" do enter when switch asks "Destination filename"

Any idea

Juha

[jobidondave]

Add the following command in config mode;

"file prompt quiet"

and then, retry your copy, you should not get back the prompt "destination filename"

[David Stanford]

You could add

copy startup-config disk:

[u346874_2]

Hi

No help for these "R" or "file prompt quiet" commands. Logging says "Jan 30 06:48:59.008 EEDST: %SYS-5-CONFIG_I: Configured from tftp://10.x.x.x

/20080130064540593-10.x.x.x.cfg by console"

Somenthing happens but startup-config i cant see in slot0:.

Juha