10-19-2010 07:30 AM
Hello All,
I am turing to the community because I have changed settings, ran the acquisition probably 15 times but to no avail. After it completes I have:
Number of Acquisition:927
Number of host entries:0
Number of IP Phone entries:0
I have tried ping sweeps of all class c networks, by subnet, by device but always 0 end hosts. The majority of my switches are 3750 with 3 2960's. I am running Campus Manager 5.2.0 . Any suggestions?
Solved! Go to Solution.
10-19-2010 09:26 PM
What version of SNMP are you using? If v1/v2c, make sure you do not have a '@' in your community strings. If using SNMPv3, make sure you have configured contexts for each VLAN on the switches. For example:
snmp-server group v3group v3 auth context vlan-100
10-19-2010 09:26 PM
What version of SNMP are you using? If v1/v2c, make sure you do not have a '@' in your community strings. If using SNMPv3, make sure you have configured contexts for each VLAN on the switches. For example:
snmp-server group v3group v3 auth context vlan-100
10-19-2010 11:56 PM
Thanks again for the help. I'm using snmp v3 so it was the snmp-server group context vlanid line. Now I just can't fine IP phones. They show up under end hosts but don't show up under IP phones when I run acquisition.
10-20-2010 09:51 PM
Make sure your CUCMs are managed properly by Campus Manager and show up as green application server icons on the Topology Map. Make sure these CUCMs allow one to poll the CISCO-CCM-MIB (ciscoCcmMIB). This is how UT will get the phone details.
10-21-2010 05:13 AM
I got them added but they showed up as Not Configured in ACS. So I created a NBG in ACS and came in to work today and now they're authorized and are showing up on the topology map. Thanks again for the help.
10-23-2010 10:06 PM
Does this mean UT is now showing IP phones as IP phones?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide