Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

User Tracking selecting subnets

I've setup user tracking to only collect from certain subnets (under user tracking > acquision > configure subnet acquisition).

It's set to collect do a mojor acquision every 4 hours and minors every 30 minutes.

The data I see in CM includes subnets that I wanted to exclude, so I am not sure what is going on. I made sure to apply the settings, and I checked the aniserver.properties and can see my list of subnets in it.

We would like to limit the tracking to just our coporate network, and keep the tracking out of the datacenter (for now, until we are sure we won't impact production in any way) . . .

Also when I add a new device (and it has a new subnet) will user tracking complain that I need to run the initial collection of subnets again?

5 REPLIES
Cisco Employee

Re: User Tracking selecting subnets

Please post your ANIServer.properties as well as an example entry which should not be appearing in User Tracking.

New Member

Re: User Tracking selecting subnets

here is the file and a SS of the a couple of the entries.

Cisco Employee

Re: User Tracking selecting subnets

What is the IP address of the switch to which these end hosts connect?

New Member

Re: User Tracking selecting subnets

10.4.21.1

Cisco Employee

Re: User Tracking selecting subnets

What is the last seen timestamp for these hosts? It appears that they should be properly filtered. And if you delete them, they should not come back.

135
Views
0
Helpful
5
Replies