Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

user tracking

can I able to see on user tracking the duplex and the speed , vtp information. or the state of of the device. any way to configure ?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: user tracking

When viewing a UT report, if you select the All Columns layout instead of the default Standard layout, you will get columns for duplex mode, port speed, and the VTP domain associated with that entry. Device state is not shown. The device had to have been up at the time the UT entry was last seen.

You can also create custom layouts showing only the columns you want to see. That can be done under User Tracking > Reports > Custom Layouts.

1 REPLY
Cisco Employee

Re: user tracking

When viewing a UT report, if you select the All Columns layout instead of the default Standard layout, you will get columns for duplex mode, port speed, and the VTP domain associated with that entry. Device state is not shown. The device had to have been up at the time the UT entry was last seen.

You can also create custom layouts showing only the columns you want to see. That can be done under User Tracking > Reports > Custom Layouts.

120
Views
0
Helpful
1
Replies