I just installed Cisco Prime LMS 4.1, and now I want the user authentication to integrate with my TACACS server. I try to add my users with the same username as they appear in Tacacs, but in LMS when I try to add a user that has a dot in it, ex: "smith.j" it says that the "." is an invalid character. Is there a way around that, because I don't want to rename every user in Tacacs, plus the fact that I want to integrate Tacacs with LDAP soon.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...