Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

UserTracking on Some Switches not working

Hi,

I'm using LMS2.5 and CM 4.0.5. The campus manager user acquisition is working fine except for the 2-3 switches. When I do UT End Host Report from device center, it showing zero end hosts. I'm sure that the hosts are connected to these switches and they are working. Configuration, communities all are checked, they are same as other switches.

Anyone know what might be the reason for this.

Thanks...

1 REPLY
Cisco Employee

Re: UserTracking on Some Switches not working

What type of switches are these? What does a show cam dynamic show for them? Do you see the hosts via the above CLI command?

If you do, then enable some debugs for UT and see what is in the logs.

110
Views
0
Helpful
1
Replies
CreatePlease login to create content