Hi! When I run UT with CM 4.0.6, I only see the mac addresses of clients assosiated to an AP. The layer 3 information located in the arp table of the 6500 carring the WLSM is missing. Does anyone know what to do that I see the ip belonging to the mac assosiated to the AP? thanks
The WLSM is not supported by Campus Manager, and will therefore not be used by User Tracking for resolving MAC addresses to IPs. You will need to make sure all of the wireless MACs are also in the ARP cache of a supported router device that is properly data collected, and shows up as green with a router icon on the Topology Map.
What version of code is the switch with the Sup720 running? When debugging missing IP issues with UT, enable vmpsadmin debugging under Campus Manager > Admin > Campus Data Collection > Debugging Options, then perform another full UT major acquisition. Then trace the MAC and missing IP address through the ut.log.
These lines are just showing the creation of the UT main table. They do not reflect what is being polled of the devices on the network. Trace the address of the switch through the log. You should see the ARP table being polled for it (i.e. a line like "using ARP table from ").
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...