Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

using event manager on 6513 switch

Hello everyone. Trying to create event manager event on 6513 switch IOS 12.2(33) to do rinning-config automatic back up but for some reason it does not work. Here is the set of commands:

event manager applet Archive_Configuration

event timer cron name "Archive_Configuration" cron-entry "0 1 * * *"

action 1.0 cli command "archive config"

It does not start applet. archive config works fine when triggered manually. Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: using event manager on 6513 switch

This applet will run every day at 0100. You should be running NTP on this switch so that the internal clock is correct.

Next, your action list is wrong. The archive config command requires enable access. So, your applet should be:

event manager applet Archive_Configuration

event timer cron name "Archive_Configuration" cron-entry "0 1 * * *"

action 1.0 cli command "enable"

action 2.0 cli command "archive config"

2 REPLIES
Cisco Employee

Re: using event manager on 6513 switch

This applet will run every day at 0100. You should be running NTP on this switch so that the internal clock is correct.

Next, your action list is wrong. The archive config command requires enable access. So, your applet should be:

event manager applet Archive_Configuration

event timer cron name "Archive_Configuration" cron-entry "0 1 * * *"

action 1.0 cli command "enable"

action 2.0 cli command "archive config"

New Member

Re: using event manager on 6513 switch

Oops, I missed enable command here. Thanks a lot for your help.

247
Views
0
Helpful
2
Replies
CreatePlease login to create content