Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Using LMS to find my non-ssh devices

I have Cisco Prime LMS 4.2 deployed.  How can I use it to determine which of my routers and switches are not configured to support ssh?   Clearly I could log into each device and do it by trial and error but I'd like something a little more elegent.    I wasn't hopeing there is a best practices report or something already built in but I don't see it.

Thank you,

Tod

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Using LMS to find my non-ssh devices

Hi Tod,

so Basically  you need the get the Capabality of the devices with SSH

As per my understanding DIRECTLY it is not possible to get this , however I can suggest you one thing:

Create a CUSTOME INVENTORY Report

Report >report designer > Inventory

you can custom the report based on IMAGE  ( usually the IMAGES with K9 have the capabilty of SSH)

check the below link:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.2/user/guide/reports/inv_reports.html#wp1125269

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
3 REPLIES
Cisco Employee

Using LMS to find my non-ssh devices

Hi Tod,

You can to check if the device are Configured with SSH  ?

Or you wanted to check if Device are capable of configuring the SSH  ?

Thanks-

Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
Community Member

Using LMS to find my non-ssh devices

I want to figure out 2 things.

1. What devices are NOT capable of SSH.

2. What devices are capabile SSH but not currently configured for SSH.

Cisco Employee

Using LMS to find my non-ssh devices

Hi Tod,

so Basically  you need the get the Capabality of the devices with SSH

As per my understanding DIRECTLY it is not possible to get this , however I can suggest you one thing:

Create a CUSTOME INVENTORY Report

Report >report designer > Inventory

you can custom the report based on IMAGE  ( usually the IMAGES with K9 have the capabilty of SSH)

check the below link:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.2/user/guide/reports/inv_reports.html#wp1125269

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
266
Views
0
Helpful
3
Replies
CreatePlease to create content