Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Using Net show

Hello,

when i create a Netshow job,it is always gives me failure status but when i click on the JOB ID to see workorder and then when i click failure it show me the command output.

pls suggest .

Thanks

1 REPLY
Cisco Employee

Re: Using Net show

The way Netshow tries to detect a failure can be problematic.  That is, if the output contains certain keywords, Netshow will think the command failed when it actually did not.  Some of this was fixed in LMS 3.2, but the potential for a false positive could still exist.

137
Views
0
Helpful
1
Replies
CreatePlease to create content