note: I have also attached the properties file for you
here are the steps:
To launch the SSH from the topology ,we need to follow the below steps:
>Go to C:\Documents and Settings\
>Use the attached file(campusmgr.properites) that he need to put in the above location.
>Made the below change
I hope the above info. will help you !!
I need your help because I cannot seem to make it work. I'm using a Window 7 client PC and I copied the
campusmgr file on C:\Users\Administrator. The campusmgr file is still the same with C:\\putty\\putty.exe. I copied my putty file on C:. When I connected to Topology Services, an error appeared. Kindly see attached for the screenshot of
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...