10-20-2009 11:57 AM
We have growing number of Vmware servers and I don't see them in the User Tracking. Is there a way to see VmWares in the UT
10-20-2009 12:19 PM
UT doesn't care about the end host type. So long as the MAC address shows up in the switch CAM/MAC table, UT will learn it.
10-20-2009 12:24 PM
But it doesn't seem to work in my case. I have this several Cisco 4510 that are fully managed in RME, I get the end host from every port but not from the ports that are connected to ESX servers, I do show mac on that port I see tons of mac address for the hosts behind esx but none appears in UT.
10-20-2009 12:27 PM
How are those ports configured?
10-20-2009 12:27 PM
Ports are configured as TRUNK
10-20-2009 02:16 PM
Then you have to allow UT to acquire the end hosts on those ports under Campus Manager > Administration > User Tracking > Acquisition > Configure Trunk for End Host Discovery.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: