10-20-2009 11:57 AM
We have growing number of Vmware servers and I don't see them in the User Tracking. Is there a way to see VmWares in the UT
10-20-2009 12:19 PM
UT doesn't care about the end host type. So long as the MAC address shows up in the switch CAM/MAC table, UT will learn it.
10-20-2009 12:24 PM
But it doesn't seem to work in my case. I have this several Cisco 4510 that are fully managed in RME, I get the end host from every port but not from the ports that are connected to ESX servers, I do show mac on that port I see tons of mac address for the hosts behind esx but none appears in UT.
10-20-2009 12:27 PM
How are those ports configured?
10-20-2009 12:27 PM
Ports are configured as TRUNK
10-20-2009 02:16 PM
Then you have to allow UT to acquire the end hosts on those ports under Campus Manager > Administration > User Tracking > Acquisition > Configure Trunk for End Host Discovery.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide