cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
521
Views
0
Helpful
6
Replies

UT not discovering MAC on trunk port with IP-phone

mmisonne
Level 2
Level 2

Hello,

I have a Lan with interfaces configured for non-cisco-ip-phone. (i.e.: Trunk port with a native data vlan.)

It is impossible de discover Mac on those ports. Note that if I telnet the switch and do a 'sh mac add-table" I see those.

I configured the LMS User-Tracking admin with:

"config trunk for end host disc. = enable on all trunk."

Do I forgot something ?

Rgds,

Michel Misonne

6 Replies 6

Joe Clarke
Cisco Employee
Cisco Employee

Edit ut.properties, and set UTGetVlansWithUserPorts=0. Then run a new UT acquisition, and your phones should show up.

Hello,

I tried to do this allreaddy.

And I did not see any change.

Here is my ut.properties.

Note that I have LMS3.1

Rgds.

Michel.

Try running a full Campus Data Collection first, then run the UT acquisition.

hi Jim,

I am sorry to call you back , but I need to do this working.

Do I need to do other thing than edit UT.properties ?

Do I need to restart LMS ?

Do I need to schedule a new inventory pooling ?

All you should have to do is run a new Campus Manager Data Collection. This will update the XML files which contain port data required by User Tracking. After the Data Collection runs, start a new UT acquisition. Your end hosts should show up.

Thanks a lot Jim. Now it works.

Michel.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: