I am fairly new to DFM I like this alert that I get but was wondering how to set the lower threshold limit to be higher than whatever is triggering the alert (suspect 45% utilisation). If I wanted to get this alert but only for say 75% utilisation how can I customise the alert to do this?
Re: Utilisation Alert DFM question re lower threshold
You can lower the Utilization threshold under DFM > Configuration > Polling and Thresholds > Managing Thresholds.
The sample alert you provided refers to a Gigabit port, configured either as Trunk or Access. Select the "1 GB Ethernet" speed under the appropriate DFM > System Defined Groups (Access Port Groups or Trunk Port Groups).
Click on "Edit". Lower the "Utilization Threshold" to the value you like. Then click "Save" and make sure to click "Apply Changes" as well.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...