Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Verifying Syslog automated actions

Dear friends,

I have some sylog messages on which i am defining an automated action. I just want to make sure that they are right.

The syslog messages that i want to try are:

1. %BGP-5-ADJCHANGE
2. %BGP-3-NOTIFICATION

Can you tell me if my settings under RME-->Tools-->Syslog-->Automated action is right?

Facility: BGP

Sub-facility: *

Seveirity : *

Mnemonic: ADJCHANGE ,NOTIFICATION

Thanks a lot

Gautam

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Verifying Syslog automated actions

Hi Gautam,

You almost nailed it. Try the following settings instead:

Facility: BGP

Subfacility: *

Severity: 5

Mnemonic: ADJCHANG

Description:*

Facility: BGP

Subfacility: *

Severity: 3

Mnemonic: NOTIFICATION

Description:*

You will need to create 2 separate lines, one for each syslog message type. The above should match the same messages you mentioned.

Regards,

Luis.

2 REPLIES
Cisco Employee

Re: Verifying Syslog automated actions

Hi Gautam,

You almost nailed it. Try the following settings instead:

Facility: BGP

Subfacility: *

Severity: 5

Mnemonic: ADJCHANG

Description:*

Facility: BGP

Subfacility: *

Severity: 3

Mnemonic: NOTIFICATION

Description:*

You will need to create 2 separate lines, one for each syslog message type. The above should match the same messages you mentioned.

Regards,

Luis.

New Member

Re: Verifying Syslog automated actions

Thanks a lot Luis for your wonderful support.

Thanks and Regards

Gautam

233
Views
0
Helpful
2
Replies