Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Vlan change audit filter

I want to enable the vlan change audit filter (RME -> Admin -> ChangeAudit -> Config Change Filter). However, when I check the option and click apply, it is unchecked again after the screen refreshes.

I use RME 4.0.5 running on Windows 2003 SP1.

Does anybody have a solution for this?

Thanks in advance

3 REPLIES
Cisco Employee

Re: Vlan change audit filter

This is indicative of a bad installation. The necessary schema entries were not added to the database. You should uninstall and reinstall RME. Since you are on Windows, be sure to set your TEMP and TMP environment variables to something short like C:\TEMP before doing the reinstallation.

New Member

Re: Vlan change audit filter

Thanks Joe. I was afraid that would be the answer.

A week ago i did a restore of the Original databases (dbRestoreOrig.pl). Do you think that caused the problem?

Cisco Employee

Re: Vlan change audit filter

Ah, that may be a bug. I have seen other cases where the orig database did not get the necessary schema changes. If you open a TAC Service Request, SQL queries can be given that will restore this table.

126
Views
0
Helpful
3
Replies
CreatePlease login to create content