When I configured some vlans below 1002 on my new 4900 switch I noticed a line in the config that reads "vlan internal allocation policy ascending" We only use vlans below 1005. Is this anything to worry about? Should I set the policy to descending?
Layer-3 Catalysts use VLAN id's internally for a few things, one of these is routed interfaces (no switchport). By default the internal allocation policy is ascending - that means it will use VLAN 1006 and upwards for internal usage. If you change this to descending it starts at 4094 and goes down.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...