Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN + Radius

Our firewalls are all set up with TACACS+ which uses Cisco ACS for ssh authentication.

I need to configure one of our firewalls for VPN using Radius, however since the firewall is already configured as a TACACS+ device on ACS I can't add it again as a Radius device, and if I change it to a Radius device then SSH stops working. Is there anyway to use the same ACS server for VPN using Radius and ssh authenitcation using TACACS+ for a single device?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: VPN + Radius

Its easier than you think, you just need a seperate authentication profile for each protocol. You'll just need to have a different name for each profile (I personally just tack a -r or a -t on the end of the hostname)

2 REPLIES
Silver

Re: VPN + Radius

Its easier than you think, you just need a seperate authentication profile for each protocol. You'll just need to have a different name for each profile (I personally just tack a -r or a -t on the end of the hostname)

New Member

Re: VPN + Radius

Ha...yea that's pretty funny that I didn't even try that...easy enough, I like solutions like this.

Thanks!

162
Views
0
Helpful
2
Replies