WAAS configuration with 3750 or 3560

[elabraham]

Hi, I'm trying to connect these two devices and still could not get it.

Could you please give me a hand with the wccp config?

Attached I post the switch conf, the wae conf and the deb ip wccp events output in the switch and the sh wccp routers on the wae.

Thanks very much.

Rgds.-

Esteban

[bennyferber]

Hi Esteban,

change the configuration on your wae from:

wccp tcp-promiscuous router-list-num 1 mask-assign l2-return

to:

wccp tcp-promiscuous router-list-num 1

and configure on the switch on the interface that connect to the waas the command:

ip wccp redirect exclude in

to prevent routing loop.

Regards,

Benny

[elabraham]

Hi Benny, I made the changes you told me so, but still no connection. Indeed I've tried all possible forms, L2-redirect, L2-return with and without mask-assing and nothing. Could you tell me some other things to try, besides this I have a doubt about the router-list defined, is it suppoused to be the ip wich the WAE is connected against or it has to be the ip range wich I want to accelerate?

Thanks.

Esteban

[bennyferber]

Hi Esteban,

You shouldnt configure L2-redirect or L2 return on the wae.

you should configure "wccp tcp-promiscuous router-list-num 1".

olso make sure you are using wccp v2 on the switch.

The router list should be the ip address of the router/l3switch.

Regards,

Benny

[elabraham]

Benny, sorry to bother you but still nothing, no WCCP L2 connection.

Attached I post the output of the wccp packets and events debug in the switch and the WAE.

Hope this could help!

Thanks a lot.

Esteban