Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wan Utillization issue

We are currently experiencing high utillization on our regional WAN connections.

In this scenario, we used to track this situation using IP accounting on the WAN interfaces.

We recently upgraded WAN routers to cisco WS-C6509-E Mutilayer switches.

When we tried to perform IP accounting on these devices, We get a warning <Accounting will exclude mls traffic when mls is enabled>

That way we cannot track the defaulting hosts.


Does anyone have an idea how we can overcome this

1 REPLY
Blue

Re: Wan Utillization issue

Looks like once on board the cat6k ship, you're going to need to switch gear to NetFlow instead:

http://www.ciscosystems.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af1.shtml#ip_accounting

"IP Accounting excludes MLS traffic

In the Cisco Catalyst 6500 series, Multiple Layer Switching (MLS) is deployed in such a way that once a flow is established, traffic is directly switched at PFC (hardware-switched) and is not processed by the MSFC, hence the lack of continuous accounting. Only new or process-switched flows (software-switched) is recorded by IP accounting when enabled, and even then only until the entry is entered into the database. Thus, the previous warning message is normally displayed when you enable IP accounting on such a platform.

6500(config)#int fa8/40
6500(config-if)#ip accounting
Accounting will exclude mls traffic when mls is enabled.

NetFlow accounting is the preferred method. Refer to Configuring NetFlow for more information regarding to NetFlow."

247
Views
0
Helpful
1
Replies
CreatePlease login to create content