You can simply export your maps from WCS then import them into a newly built Prime 2.0 server once you've added the controllers.
The 2nd option is a whole lot easier and a whole lot faster but any customization you've done in WCS like special reports, added users to access the browser and other mods like TACACs settings as well as performance datawon't come over but if you're intested in just getting the maps and AP placement, go this route
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...