Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

What file are Alerts stored in in DFM 2.0 ?

Hi,

I am getting an unidentified trap message in DFM 2.0. The message was generated by a switch that is no longer there and I cannot remove the message.

I would therefore like to delete the file from source but have no idea where alerts are stored.

Anyone have any idea on this ?

1 REPLY
Silver

Re: What file are Alerts stored in in DFM 2.0 ?

Think, you cannot remove the indentified trap. DFM may display an event as an Unidentified Trap. Normally an Unidentified Trap is reported when an event occurs on a device that is being discovered by DFM. You can get more information on an Unidentified Trap by looking at its Events page.

Pass-Through SNMP Unidentified Traps are traps that DFM receives from devices that are not in the DFM inventory. These traps are shown in the Alerts and Activities display because of their relevance to fault monitoring. Pass-through traps are displayed as follows:

As one of the following events:

InformAlarm

MinorAlarm

MajorAlarm

With the device type and the device name from which it was generated

If DFM does not know which device generated the trap, it ignores the trap

108
Views
0
Helpful
1
Replies
CreatePlease to create content