Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What kind of log I can get with "level informational" - c2950 & 6500

Hello, everybody, It is nice to meet you. I am working in Tokyo in japan as network engineer.
It is my first time to write something on here Cisco Support Community and I don't speak English very well.
So I hope everyone understand my pour question and writing. But I wish somebody anwser to this question.

I am using kiwi sever to manage four of 6500 and about thirty of c2950.
The kiwi server is working normally logging both 6500's syslog and c2950's.

But I have question about difference between 6500's level informational and c2950's.

For example, When I log in 6500 I can get a log from my kiwi server.

And When I enter some command to change config I can also get a log from my kiwi server.

However When it come to c2950 I can't get the logs. I can only get logs that notice 'interface up/down' or 'changed config' stuff like that.


I think I have correct config about logging both 6500 and c2950 as follow.

Trap logging: level informational, OOOOO message lines logged
        Logging to XX.XX.XX.XX, OOOOO message lines logged, xml disabled,
               filtering disabled


Anybody know what kind of log I can get with "level informational" on c2950.

Thanks everybody.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: What kind of log I can get with "level informational" - c295

Information is a fairly low severity which means you'll get everything except debugging messages.  This includes link up/down, config change,

CPU hog, etc.  If you're not seeing messages other than link up/down and config change, then there may not be anything else happening on the switch which triggers a log message.  Check the output of "show log".  That should agree with your syslog logs.

1 REPLY
Cisco Employee

Re: What kind of log I can get with "level informational" - c295

Information is a fairly low severity which means you'll get everything except debugging messages.  This includes link up/down, config change,

CPU hog, etc.  If you're not seeing messages other than link up/down and config change, then there may not be anything else happening on the switch which triggers a log message.  Check the output of "show log".  That should agree with your syslog logs.

223
Views
0
Helpful
1
Replies