Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

What makes a device "unreachable"

I have 1400+ devices in LMS, however some of them are listed as "unreachable" - what should I be looking for in terms of making them reachable. I can ping them so they are on the network, its just that LMS says they are unreachable???

1 REPLY
Cisco Employee

Re: What makes a device "unreachable"

You should check snmp connectivity to the devices. Do they have snmp ro and rw comm strings? Do the strings on the device(s) match what you have entered for credentials in LMS?

Start with one device and check its snmp connectivity. If snmp is set up and the DCR has the same, then try using the snmpwalk utility in LMS. If it works, then try a packet capture while attempting to discover/add the device.

Is CDP enabled on the device??

125
Views
0
Helpful
1
Replies