Where is SSH device certificate information stored in LMS 4.0
I have 40 switches which have changed management IP addr.. After the change 11 out of 40 devices fails in the "device credential verification report". It says it can't connect via SSH. If I make a SSH connection using Putty from the LMS server to these devices, then it's OK. I suspect it can be an issue with an old certificate stored in LMS that causes this problem. Where is the SSH information stored ? or could it be another problem ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...