Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

why I could get "Partially Successful " error message?

The error message is:

1. yy-6513-1 VLAN RUNNING May 05 2009 03:00:28 SSH: Failed to establish SSH connection to 172.x.x.x - Cause: Authentication failed on device 3 times. VLAN Config fetch is not supported using TFTP.TELNET: Failed to establish TELNET connection to 172.x.x.x - Cause: Connection refused.

2. yy-6513-1 PRIMARY RUNNING May 05 2009 03:00:25 Successful

3. yy-6513-1 PRIMARY STARTUP May 05 2009 03:00:14 Successful

why I have authentication issue on VLAN if I could archive the configuration of running-config and start-config?

please advice! Thanks a lot!

2 REPLIES
Cisco Employee

Re: why I could get "Partially Successful " error message?

The vlan.dat can only be archived using telnet or SSH. The startup and running configs can be archived using other protocols such as TFTP/SNMP. This error points to invalid telnet/SSH credentials in DCR for this device. Re-enter the username and password credentials for this device in DCR, and make sure you can connect to this device from the LMS server, and login successfully.

New Member

Re: why I could get "Partially Successful " error message?

Thanks, i will try it again soon!

212
Views
0
Helpful
2
Replies