Why the LMS topology Service takes long time to reflect the device availability status?
In the topology services map, the color status of the router takes long time to move from red to green and vice versa.
i have already configured the time interval in the fault monitor poller setting to 6minutes but the only thing reflected the little mark at the top of the icon itself. anyhow the topology service still believe that the devices are unreachable. i have waited almost 45 minutes and nothing happened.
please let me known the trick to make the topology services act more quicker .
Re: Why the LMS topology Service takes long time to reflect the
Topology Services isn't really designed to be a near real time network device up/down tool. It will an change icon's status as a result an ANI engine polling cycle or an admin operator-initiated manual device rediscovery. While you can increase the frequency of polling cycles, that's not usually such a good idea as you could make the server be polling constantly and never completing a job.
To ascertain near real time fault status one should refer to the Fault Dashboard.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.