On CWLMS Prime, currently you can not manage AP's as stated below:
How is a device defined within CiscoWorks device counts?
A. A device is defined as a unique IP Address and System Object ID (SysOid). A single chassis will be counted as multiple devices if the chassis is configured with multiple IP Addresses. Ex. A switch with multiple line cards, NAM, firewall etc. or a stackable switch that has an IPAddr assigned to each switch that participates in the stack will be treated as multiple devices within CiscoWorks. Note:IP Phones and controller based access points do not count as managed devices within LMS.
Will there be a new release that will eventually allow management of these AP's
Controller-based access points are managed under their respective controllers. Those controllers can be managed by LMS. Autonomous APs can be managed directly by LMS.
Note Cisco Prime 4.2 appears to be integrating the LMS (typically more LAN-based) and NCS (more wireless-based) functions under a single product suite. (The data sheet had been posted earlier this week but now appears to have been pulled temporarily from cisco.com.)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.