Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

wrong credentials on multiple network devices...

I generated a report on Device Credentials using Device credentials Verification job and it cames back with wrong SNMP credentials, here's the weird bit.

I checked SNMP R & RW on the successful devices and failed devices, both have the same R and RW community strings!! Any ideas?

Thanks

  • Network Management
1 REPLY
Cisco Employee

Re: wrong credentials on multiple network devices...

It takes more than correct community strings for RME's Device Credential Verification to work.  First, the devices must be SNMP reachable from the RME server.  Have you verified the SNMP packets are making it to the devices?  If you run a "debug snmp packet" on the non-working devices, do you see the incoming requests from RME?  Do those requests make it back to the RME server.  Next, check that if you have community string ACLs applied on the non-working devices that they allow the IP address of the RME server.

246
Views
0
Helpful
1
Replies
This widget could not be displayed.