Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WS-C2960+24TC-L System Temperature Status via SNMP

Hi all,

I need to diagnose System Temperature Status (Board Temperature) via SNMP on my device WS-C2960+24TC-L.

I found the following OIDs:

chassisFanStatus 1.3.6.1.4.1.9.5.1.2.9.0

(other (1) - none of the following, ok (2) - status OK, minorFault (3) - minor problem, majorFault (4) - major problem)

and

chassisTempAlarm 1.3.6.1.4.1.9.5.1.2.13.0

(off (1) - temperature within normal range, on (2) - temperature too high, critical (3) - critical temperature, system shut down imminent)

In normal state I displayed the following states in concole:
bila_tremesna>show env all
FAN is OK
SYSTEM TEMPERATURE is OK

POWER is OK
RPS is NOT PRESENT

21.4.2016 8:21:23 (152 ms) : 1.3.6.1.4.1.9.5.1.2.9.0 = "2" [ASN_INTEGER]

21.4.2016 8:21:23 (195 ms) : 1.3.6.1.4.1.9.5.1.2.13.0 = "1" [ASN_INTEGER]

When I disconnect the Fan, the FanStatus goes to "4" and in console is displayed:

bila_tremesna>show env all
FAN is FAULTY
SYSTEM TEMPERATURE is FAULTY

POWER is OK
RPS is NOT PRESENT

21.4.2016 8:21:12 (144 ms) : 1.3.6.1.4.1.9.5.1.2.9.0 = "4" [ASN_INTEGER]

21.4.2016 8:21:12 (188 ms) : 1.3.6.1.4.1.9.5.1.2.13.0 = "1" [ASN_INTEGER]

So, in the console, the state of System Temperature is changed to FAULTY, but in SNMP is "1" (not change). Is this correct state?

Thank you

VojKrej

Everyone's tags (4)
3 REPLIES
VIP Purple

What software version are you

What software version are you using?

New Member

Here is the version:

Here is the version:

Cisco IOS Software, C2960 Software (C2960-LANBASEK9-M), Version 15.0(2)SE6, RELEASE SOFTWARE (fc2)

ROM: Bootstrap program is C2960 boot loader
BOOTLDR: C2960 Boot Loader (C2960-HBOOT-M) Version 15.0(2r)EZ1, RELEASE SOFTWARE (fc1)

Thank you for your reply

VIP Purple

Hmm, I suspect this will be a

Hmm, I suspect this will be a platform limitation then.

84
Views
0
Helpful
3
Replies