CW LMS RME can't manage the archive for a NAM2.I get the error message below. I double checked the username and password, and succeeds while telenting manually. A sniffer capture shows that CW is able to connect to the NAM (the prompt is there), nonetheless it fails.
CM0062 Polling namdmz1 for changes to configuration. CM00 Polling not supported on PRIMARY RUNNING config, defaulting to fetch. CM0151 PRIMARY RUNNING Config fetch failed for namdmz1 Cause: TELNET: Failed to establish TELNET connection to "hidden"- Cause: Authentication failed on device 3 times. Could not detect protocols running on the device Action: Check if protocol is supported by device and required device package is installed. Check device credentials. Increase timeout value, if required.
The problem you are seeing (CSCsy73881) does not have a fix in RME 4.0.6. It is fixed in RME 4.3 with the availability of a new cmdsvc.properties file which allows you to adjust some of the internal timers. And, since RME 4.0.6 is currently end of engineering, I do not see a patch coming out for your version. If you were to upgrade, you would need to edit cmdsvc.properties, and set:
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...