ASA 5510 FW IP Sec Tunnel

[Nay Myo Tun]

Hi Gentlemen,

                   I am not very experienced in ASA FW. I hve 2 sites setup using Site to Site IP Sec VPN by ASA 5510 Basic license. The problem is that the video traffic sent from Site A to Site B via the IPSec tunnel, it is very slow and latency is quite high.

( 1 ) Am i able to create multiple tunnels in Site A to site single tunnel at Site B?

( 2 ) Am i able to create the multiple tunnels within single VLAN in Site A? Or need to create the multiple VLANs in Site A in order to create multiple tunnels?

( 3 ) Does ASA 5510 FW support 1 to 1 IPSec VPN tunnel or 1 to many IPSec tunnel?

( 4 )  ASA 5510 FW IPSec VPN tunnel able to establish the IPSec tunnel with Nortel 5000 Series VPN appliance?

Thanks

[joyride_us2]

Hi,

no problem to create multiple tunnels and set your Video traffic as "interesting traffic" for the 2nd tunnel. However, I am not sure this is going to help you. You might want to QoS your link for your Video traffic to have guaranteed bandwidth.