ASA Firepower Status -Connect to ASA Firepower application

[inderjit21]

I have lost Firepower under Configuration . I can see it there. I need to upgrade Firepower version.

Under - ASA Firepower Status -Connect to ASA Firepower application I only see https://No DC Configured

Do I need to configure IP in here to be able to connect to firepower.

[Jetsy Mathew]

Hello Team,

This can occur due to multiple reasons. To start with it you , first of all you have to confirm that you finished the installation of both .img and .pkg file successfully without any issues using the following link.

http://www.cisco.com/c/en/us/support/docs/security/asa-firepower-services/118644-configure-firepower-00.html

Also verify that you have choose one of the following connectivity scenario from following link since this is the only supported deployment setups.

http://www.cisco.com/c/en/us/support/docs/security/ips-sensor-software-version-71/113690-ips-config-mod-00.html

(ips connectivity setup is applicable to sfr also.)

If you confirmed all of the above, then  as a next step could you please check, if the ASA FirePOWER Status tab is present by clicking the Home icon in the ASDM .

Is t only the ASA FirePOWER Reporting tab and the ASA FirePOWER Dashboard are missing ?

Rate if answer helps you.

Regards

Jetsy