Connection to service.brightcloud.com and database.brightcloud.com with telnet works finde.But a database download should not work. SF-IMS[4407]: [4432] CloudAgent:CloudAgent [WARN] DownloadURLDBFilesOnDC: URL Database update: Malformed message rec...
Forum Posts
Hi All i have ASA 5525 connected to DMZ server cisco2960 and core switch 4500 series(VSS configured on it) and i connected asa5525 with the core switch using port channel and i want the dmz network to access the internal core side network and vice ve...
Hi, I've ASA5585-SSP-40 appliance i want to know that can we manage ASA Firepower (ASA5585-SSP-SFR40) by using ASDM?, or we compulsory require Firesight management center? I could see in cisco web side that we can manage Firepower with ASDM if we...
Hello everybody. I have a problem logging into firepower web panel as admin. It bans (?) me after 2-3 minutes of activity. Nothing in logs, just drops my connection to its panel. Host is reachable, can ping it. Added my ip to whitelist, it didnt help...
Resolved! Failover mode - Public IPs
Hi all, I've got two Cisco ASA 5510, where there is on primary and another one as Standby failover. They both have a public IP address. Primary: 201.201.201.201 Standby: 203.203.203.203 PRIMARY ASA: Failover On Failover unit Secondary Failover ...
No matter the same OID value of the primary and secondary firewall , can I distinguish the status（primary or secondary） of the devices. for example: what's mean of the OID?is the 1.3.6.1.4.1.9.9.147.1.2.1.1.1.2.6 represent the primary device? 1： OI...
Hello, I am converting an ASA configuration to a Firepower configuration using Firepower Management Center Virtual GUI. The conversion tool is asking whether I want to convert ASA access rules into Prefilter Policies or Access Control Policies: ...
I just loaded both license for URL Filter & Malware. Status of license shows valid. However my policy has these warnings.Block Unacceptable URLs - Error: This rule requires a URL Filtering license, but at least one device does not have a URL Filter...
Hi All, Please can you help me?
Resolved! Anyconnect client profile
Hello,some doubts about anyconnect..1. I've created a client profile, then associated it with a group policy, and changed some preferences settings. When I install anyconnect by web-deploy under client preferences those settings are not corresponding...
Resolved! Firepower http prevention setup
Hi all, I am new in using the Firepower software. Now I'm configuring the ASA 5525-X with SFR. About HTTP, SNMP, FTP, ...protocols prevention setups, I'd like to find some cisco documents for the configuration examples, either by CLI commands or by...
Hello Everyone, I am wondering why some of our sensors are displayed by IP while others are displayed by name on the Health Monitor page of our Defense Center (5.4.1.8). I was thinking this could be a bug or maybe have something to do with the way ...
Hi, I need to setup a site-to-site VPN but want to open some ports, a limited number of ports. Is this possible with a RV325 firewall ? regards
I created some acess-lists, and you can assign a logging level to this access-list. Now this ACL has a lot of hitsso i want to see whats happening. Only the log I then see is completely empty. I cannot figure out how to get some info in that log.
Hello , We have a Cisco ASA 5585 SSP20, SSP-IPS20, we found that the memory of the IPS reaches 92%. We need to know if this usage rate is normal ? attached screenshots. Thank you.
