Hi please any one could support me to configure the NTP server on my Network, i am using cisco router 2911 and an ASA 5520 firewall, i already install the net time service on my server in the office internet based zone but when i am trying to do the...
I did a configure factory-default on a 5505 and after the reboot it set the asa back to the internal interface 192.168.1.1 and everything else as expected. But why did it stil use the previous password that was set when I when into enable mode? I fig...
Hello,I need to copy a 5505 config from one asa to another 5505. Since the IP's and hostname will be different, can I just edit a copy of the source config and then paste it into the target 5505? Can someone please give me a step by step on how to c...
I would like to implement a guest wifi network on my preexisting private network and can't figure out the security on my firewall. Currently the link connecting my private network to the internet is functioning fine and I really don't want to change ...
Hello guys.I am having issues with NTP syncing on one of my ASA's. I configured the NTP server that is behind another ASA and both ASA's exchange routes via EIGRP. Any help on this would greatly be apreciated.thanks NTP Server IP address: 172.31.254...
hi all,i've enabled traceroute on my ASA 5505 and behind is another router.the problem is the two device's traceroute aren't the same. i want a similar output on the ASA.is this normal or was there something i've missed?1841#trace www.google.comTrans...
Hello experts,Iam running some tests for ext vendor connectivity and when connecting my test 3560G g0/1 (access port) to ASA5505 (9.x) Eth0/5 (or any port), noticed increase in "switch ingress policy drops" (via show in eth0/5 o/p). Checked in the fo...
HiI configurate ASA's in active active mode. I create 10 context's in Primary ASA. 5 context are in group1 in ASA1 and 5 conetexts are in group2 in ASA2.The problem assign ip address to outside interface of context's.I use int gi0/0 and gi0/1 for out...
Hi allWe are currently using ACS for wireless authentication. Guests register over an external Sharepoint webpage. The REST API is used to create and later delete these temporary users in ACS.Now we want to migrate to ISE. In contrast to ACS, the ISE...
Having a problem with an ASA5520 system in that Backup and Restore configuration option under the ASDM Tools menu is not displayed/available. Any ideas as to why this is? ASDM version supports it as far as I can see. Further details:- ASDM/ASA ver...
Hello,I am trying to setup IPv6 tunnel to tunnel-broker Hurrican Electrics. IPv6 connection is working OK only if I disable zone security on WAN interface (Fe0 - IPv4 interface).Which protocols must be alloved to and from router?IOS version: 15.1.2T1...
Hello all,Cisco networking is new to me, I'm working on an ASA 5510 vers 8.2(5). From the ASDM I can ping to 4.2.2.2 but from the inside network I can't ping to the internet or browse. I've searched and compared my config to others on the forum wit...
Yeah I know this has been covered already. I have the following issue. I have a two segments on the firewall, behind these 2 segments I have two L3 devices. VL622 is the higher security interface at 80 while VL621 is lower at 70.I have a static:stati...
