Network Security

Hi,I have Cisco ASA5515-X with SSD. I understand that CX  has evaluation period for testing  with AVC & WSE.I am able to run PRSM Single Mode without any issue.I am facing the issue right now  when redirecting the traffic to IPS Module, it stated:WAR...

Hi guysI have configured the router to forward traffic to my server hosting netflowMy Netflow  server IP is 192.9.200.7 and its listening on port 9996My router IP is192.9.200.254 and netflow has been enabled with following commandsIP-flow export sour...

Hi All,We are using Pix 535 as an external FW in our network and we are expiriencing high CPU utilization. The CPU is jumping to 60%-70% every 60 min.I am using Cacti to monitor all the interfaces and we don't have a huge traffic that interface. Also...

I am trying to install a CA issued certificate into an ASA and need to apply it to the management interface.I am able to successfully create the certificate in the ASA but when I access the ASA's mangement IP via web browser, I am still getting self ...

Hi,We experience an automatic failover from our Cisco ASA, our standby just went active without any changes on the config and problems on our network. We are not able to get some logs during the failover. From the output below, I would like to seek f...

HiI am trying to determine why Comcast Business Class modem configured with a static IP (IPV4) works with a laptop or Linksys Cable modem but not with a Cisco ASA 5505. After a few minutes, the 5505 stop passing web traffic. I am able to ping the def...

There is some disagreement among members of my IT staff over a PCI-compliance scenario.I have two networks connected through an intermediate corporate network. One of the networks resides behind a firewall (FWSM) and a F5 with a layer 7 firewall. Cli...

Hi, I have a customer that has a pair of firewalls connected using a separate Stateful and Failover interface.  I would like to amalgamate the two together.  Would there by any impact with moving the Stateful interface onto the failover interface?  I...

Hi,I have some ASA 5510 in under setup now.  I got some problem and I would like to connect the Management0/0 to Interenet but it will not same is subnet of "outside" interface.  What should I do.  Following is my part of interface setup:------------...

Hello,My current network is like, have 2 ISP that is directly terminated on asa 5505 , on that Site-to-Site VPN is already working with vpn failover with both isp through sla monitoring. My requirement is loadbalace with both ISP traffic should pass ...