Hi everyone,Curious to know when i do sh conn it always show TCP outside to inside or TCP outside to DMZEven if i try to access the server in DMZ from outside or when i open the websites from PC behind the DMZ or inside interface.RegardsMAhesh
Hi.I have small question.If I run'reload in 1:00 noconfirm 'Does it mean, that I can make any config changes. And if I don't run 'wr mem', it reload with old config aftrer one hour?Is there any limitation running commands, i.e. can I safely make fail...
Hi guys, I have a backup server, which should backup the router configuration files securely for a list of routers. My colleagues applied this in Juniper but unfortunately am unable to figure it out on Cisco routers. The requirement is as follows: I ...
Hi Team,I am in need to run some script on Cisco ACS Server 5.3.Which i am trying to do but its not possible.I am able to login using the credentials but not able to execute the commands.I've found somthing like "Authenticating Using keyboard Interac...
Hi there...I am really hoping someone can shed some light on a way to get past this issues below.I have an ASA5512-X with ASA 8.6(1)2For the outside, I have 2 of the NIC ports configured as 'redundant' with multiple subinterfaces, each with their own...
Hi,I am having an issue with our ASA 5510 that has a SSM-CSC-10-K9 module installed. We were scanning inbound smtp traffic and outbound http traffic with the CSC, doing email virus scanning, email reputation spam filtering and http filtering and bloc...
I have a 2901K9 router at a remote location. Insite Interface = 10.10.10.1/24 Outside Interface = 20.20.20.1/24I have set "no ip directed boradcast" on both interfaces. ( I think it's the default settings)But still when I ping 20.20.20.255 I get a re...
I have to determine the internal IP address based on the external IP address and tcp port number.I am extremely new to ASA's and have been poking around unsuccessfully...Report:Jun 7 15:47:54 2013 UTC [Classification: A Network Trojan was Detected] ...
Hello, In Zone Based Firewall (ZBS) on ISR routers there is the feature "zone pair". It is very convenient to set up different policies between different zones and its directions (e.g. INSIDE-DMZ, OUTSIDE-DMZ, DMZ-OUTSIDE, INSIDE-OUTSIDE and so on). ...
Our current project involves integrating a couple of systems between two seperate networks. These networks are owned by independant parties, and there is some address space overlap. Can implementing NAT on the firewall alone solve this issue, or do...
Hi Everyone,Need to confirm here the traffic flow between 2 FW.Say we have Core Switch 1 it is learning route to subnet 172.x.x.x via interface x of Routed FW.Routed FW learns Route to Destination subnet 172.x.x.x via its interface Y.Now Interfa...
Hi All,As per attached network diagram I have 2 firewall connected to L3 switch. Since specific route is present already I am nt able to route same specific route to other firewall.PBR cannot be done in ASA. So how can I fix this issue?
Hi Pals,I know that configuration in 8.2.x and 8.4.x is different in terms of NAT and object groups.I just want to know is it possible to do a direct upgrade from 8.2.3 to 8.4.x ??Secondly, will ASA automatically convert all the configuration from 8....
