Network Security

Hi,I am trying to find the best url filtering solution for our network.We have a ASA5520 with an ASA-SSM-10 module connected to a 30mb DIA. We are trying to cut access to a number of web sites.The experience I've had in the past when enabled the url ...

We just switched to a 5510 from a PIX 515 last evening, and the only things that are not working are any services from the outside to the inside.  Example: I am unable to connect to a RDP server on the inside from the outside.  I've been looking at t...

I was advised to repost this subject here, so giving it a try:Hello!Although I've seen similar discussions, I'd like to request help in my particular scenario.We have a data center with servers set up for different projects, some servers from partner...

Greatings!Gyes, we had such kind of issue: while installing 2 SSM-4GE modules to 2 ASA 5540 (Active/Standby) the firewall is splitted. That's my step:1) Turn off standby ASA and plug SSM-4GE module2) Power it OnAfter it was booted up failover relatio...

Hello. Running ACS SE 5.1 with 5-1-0-44-6 patch and have following alerts every 2 hours:Cisco secure ACS - Alarm NotificationServerity: CriticalAlarm name: System Alarm [Collector]Cause/Trigger: Store failure (xxx, SystemStatus)I'm storing backups to...

Hi My configuration is as follows ISP1 (primary)                           ISP2 (backup)Cisco 800 series                     Cisco 800 series          |                                             |          |___________      ________ |              ...

Dear bossPlease see my attachment.I want to do static NAT  203.88.148.85 ->172.29.1.5 and 192.168.0.241->172.29.1.5That means all outsider will get mail server by 203.88.148.85 and local user will get mail server by 192.168.0.241.For that i did : rou...

Hi, hopefully a quick question on the use of a pair of ASA 5585's in active/active mode with a shared outside interface.Last time I did this was with FWSM, there was a restriction where all contexts that share an outside interface have to be in the s...

Hi guys.Need little help here with Failover, i have configured Failover Active/Standby and it was running few months but now its not working. and when i try to debug it its giving me these messages.vpnfol_thread_timer: HA MSG: no Buffer available for...

Hello, I am using ASA 5505  as a transparent firewall. I  have assigned ethernet 0/0 as outside interface and ethernet0/1-7 as  inside interface. There are 3 departments in office. So, i connected  ethernet 0/1 to Dept A, ethernet 0/2 to Dept B and ...

Ok, I am at a loss on configuring a new ASA5505 for multiple static port translations.I would have expected to simply add several service command to a network object to complete the task, however, the service command overrides the previous and replac...