Network Security

Hi,Is it possible to make a site-to-site vpn connection between two real natted ip addresses. I have a private ip address in my inside network and it is static natted to an public ip address. Is it possible to make the crypto maps with this public ip...

Hi all,I did pass on the SNAF exam and now I would like to study for SNAA exam. However, I haven`t found material to study it.Do you know what material I can use to study?Thanks

Can we configure GRE-Tunnel on ASA 5510if not then what would be next option for configuring HUB and spoke toplogy in ASA firewallthanks in advance

My question belongs to a Cisco 1712 (128 MB, IOS 12.3T, SDM 2.5 installed):I'm trying to change the default action "alarm" to "alarm,reset,drop" for all signatures of my custom set.However doing so via SDM fails. First, it appears as being done corre...

i can login into ASA,but don't interactive with lan.the config :hostname(config)# interface ethernet0hostname(config-if)# ip address 10.10.4.200 255.255.0.0hostname(config-if)# nameif outsidehostname(config-if)# no shutdownhostname(config)# isakmp po...

Hi everyone,I am trying to TFTP from ASA5510 on a different subnet that's connecting through a tunnel to our head office subnet...This is the last message I see before my dos session times outDestination filename [running-config]?Cryptochecksum: 75d5...

We have Cisco VPN concentrator 3030. We have configured WebVPN for accessing our internal web sites. We are able to connect to our Internal sites but having problem in veiwing pdf files. Any solution

Hi,I have configured the IPS Appliance and the IPS module on ASAs... now I need to configure an IDSM-2 on a 6500.Is it basically the same thing? I need to configure it as an IDS first, then we will change it to IPS, so I understand that I can use SPA...

event manager applet vpn_tunnel_unreachable event track 456 state down action 1.0 reloadI need it to reload only once if tracked object 456 is down. It should reload the router and then if the tracked object is still down it should go into dial backu...

Hello.I need a ciscoworks 2.6 and 3.2 make the upgrade to the product CWLMS-3.2-1.5KUPK9.The installation can be done on this hardware?Intel Pentium 43.2 GHz4 GB of RAM80 GB HDWindows Server 2003 S.E.SP2I need to take into account?thanks

Hi everyone. I need to downgrade the IOS from 8.0.4 to 7.2.4 on a 5510 due to VPN issues with a non cisco device. no problem, the downgrade went fine. Upon reboot, it read the config and said that a couple hundred lines were invalid (see below). Is...

I have added new static routes to my 3030, but the clients never receive the new static routes.

I've configured a 5-site system, with PIX501's at head office + 3 sites, and a ASA5505 at the 5th site. All is working as I want it to with the PIX-to-PIX tunnels but I have 2 issues with the ASA-to-PIX tunnel:1) At the ASA site, in Entire Network, ...

I have seen in a manual that you can use "interface (interface name)" as the source/destination in an ACL on the ASA. When would you do this? What exactly does it buy you i.e. what does it really give access to? Exmpleaccess-list dmz permit tcp in...