Network Security

I have two identical ASA 5510's and would like to create a tunnel between them so that I can replicate backup data. My old 281l's at each end could not handle the traffic. On my data center end I use 198.61.64.0 /17 and 198.90.152.0 /24 on the othe...

I've setup 2 UC500 with site to site vpn over the internet. Can I configure an ISDN backup for the crypto tunnel ? If yes, can I find a sample config ?ThxFilip

Anyone can help to explain the SNMP trap behaviour of ASA when there is interface failure or chassis failure occurred.For example, 1)When one of the interface failure,firewall failover occurred, which firewall will sent out the SNMP traps, the failed...

Hi guys,is there anyone who configured a native IPSEC VPN site to site with a Windows 2000 server ?Best Regards,Mustapha.

Hi All, I have the following Inquiry, as the below Question and answer. can Anyone help me how can I terminate a VPN connection using the switch ? what are the requirements ? is there any link that elaborate that? Q. Can I terminate VPN connections o...

Hi there,I am establishing a Site-to-site VPN connection with one of our clients and this just the first time we are using integrated Services SPA of CISCO installed to our 7609 router.The configuration and logs is attached in this one. I am basicall...

I would like to seek advices regarding to Cisco Firewall Module [WS-SVC-FWM-1] and IPv6 network. At this moment, our server farm is capable to support IPv4/IPv6 network, and our servers are starting to use both to serve our end-users. My questions ar...

When viewing the log messages on the ASA in the buffer or real time view you can right click and select Show rule. It should show you the rule that generated the syslog entry. On our ASA ver 8.0 we've benn making changes our Sec Admin asked for and n...

hello,i am using ASDM 5.1 for firewall ASA 5540 in that i got some error when i apply ACL from inside to intranet its generate to inside to outside and show me incomplite command.for this what i do change in my network ASA.and its generate acl is lik...

Hii have ASA 5520 with 3 interfaces : inside , DMZ , outside . on the inside network , we have websense server (10.0.10.5) . For the inside users , the websense is working fine . On the DMZ interface that is configured for the guests only , the webse...

I have a VPN set up between sites, however traffic is following a static route on the firewall rather than the established VPN path?I can I change priority/force the traffic to cross the VPN instead of the static route?I cannot delete the static rout...

Hi allI have a Cisco ASA5505 with 7.24 image and asdm 5.23. Everything was working well and fine in Routed Mode. Later I changed the device to transparent mode and then i can't able to connect through ASDM and telnet.Could anybody please help me ou...